Mesh
topology will definitely be taken into consideration. I will definitely have a thorough
look at Neil's paper as well. Thanks a lot. Another factor that makes me drive away from a
tube mic is the time that it takes to warm up. In a broadcast system a client usually
comes up with a commercial asking you to complete it in an hour. And Safeandsound123, I dont like the round table system which is currently been followed in broadcast radios. You would know what its problems are. But no one actually cleared my primary concern. My doubt is that will the fat sound from Fearn’s VT1 get a bit thinner when it passes through RME? If so, then any suggestions for an interface?
Post Extras
|
Flat
Edit
Reply
Quote


