Q. How can I warm up my recording without using EQ?

Published in SOS May 2012
Bookmark and Share

Sound Advice : Recording

I've put a lot of effort into creating and editing a recording of solo mandolin — played quite slowly — and although I like the final result a lot, on consideration the tone is too trebly and cold, almost like a photograph with too sharp a resolution. A friend mentioned he thought I could perhaps 'warm it up' using compression, perhaps of a type designed for vocals. Can you give me some guidance on how best I might do this? Of course, I realise I can use EQ, but would specifically be interested in any thoughts on how compression/limiting could be used on an existing take to get a warmer result. I've used Logic and the recording is clear, undistorted, and free from ambient sound.

Simon Evans via email

SOS contributor Mike Senior replies: There are ways to warm up a mandolin sound subjectively using compression, although none of them are likely to make as big an impact as EQ. Fast compression may be able to take some of the edge off a mandolin's apparent tone, for instance, assuming the processing can duck the picking transients independently of the note-sustain elements. There are two main challenges in setting that up. Firstly you need to have a compressor that will react sufficiently quickly to the front edges of the pick transients, so something with a fast attack time makes sense. Not all of Logic's built-in compressor models are well-suited to this application, so be sure to compare them when configuring this effect; instinctively I'd head for the Class A or FET models, but it's always going to be a bit 'suck it and see'. The second difficulty will be getting the compressor not to interfere with the rest of the sound. The release-time setting will be crucial here: it needs to be fast enough to avoid pumping artifacts, but not so fast that it starts distorting anything in conjunction with the attack setting. Automating this compressor's threshold level may be necessary if there are lots of dynamic changes in the track, for similar reasons. Applying some high-pass filtering to the compressor's side-chain (open the Logic Compressor plug-in's advanced settings to access side-chain EQ, and select the 'HP' mode) may help too, because the picking transients will be richer in HF energy than the mandolin's basic tone.The Advanced Settings panel in Logic's built-in Compressor plug-in contains side-chain equalisation facilities that can be very useful if you're trying to sensitise (or desensitise!) the compressor to a mandolin's picking transients.The Advanced Settings panel in Logic's built-in Compressor plug-in contains side-chain equalisation facilities that can be very useful if you're trying to sensitise (or desensitise!) the compressor to a mandolin's picking transients.

Another way to apparently warm up a mandolin is to take the opposite approach: emphasise its sustain character directly while leaving the pick spikes alone. In a normal insert-processing scheme, I'd use a fast-release, low-threshold, low-ratio (1.2:1 to 1.5:1) setting to squish the overall dynamic range. Beyond deciding on the amount of gain reduction, my biggest concern here would be choosing an attack time that avoided any unwanted loss of picking definition. In this case, shelving a bit of the high end out of the compression side-chain might make a certain amount of sense if you can't get the extra sustain you want without an unacceptable impact on the picking transients.

Alternatively, you might consider switching over to a parallel processing setup, whereby you feed a compressor as a send effect, and then set it to more aggressively smooth out all the transients. The resulting 'sustain-only' signal can then be added to the unprocessed signal to taste, as long as you've got your plug-in delay compensation active to prevent processing delays from causing destructive phase-cancellation. Using an analogue-modelled compressor in this role might also play further into your hands here, as analogue compressors do sometimes dull the high end of the signal significantly if they're driven reasonably hard, giving you, in effect, a kind of free EQ.  .


October 2014
On sale now at main newsagents and bookstores (or buy direct from the
SOS Web Shop)
SOS current Print Magazine: click here for FULL Contents list
Click image for October 2014
WIN Great Prizes in SOS Competitions!

 

Home | Search | News | Current Issue | Tablet Mag | Articles | Forum | Subscribe | Shop | Readers Ads

Advertise | Information | Privacy Policy | Support | Login Help

 

Email: Contact SOS

Telephone: +44 (0)1954 789888

Fax: +44 (0)1954 789895

Registered Office: Media House, Trafalgar Way, Bar Hill, Cambridge, CB23 8SQ, United Kingdom.

Sound On Sound Ltd is registered in England and Wales.

Company number: 3015516 VAT number: GB 638 5307 26

         

All contents copyright © SOS Publications Group and/or its licensors, 1985-2014. All rights reserved.
The contents of this article are subject to worldwide copyright protection and reproduction in whole or part, whether mechanical or electronic, is expressly forbidden without the prior written consent of the Publishers. Great care has been taken to ensure accuracy in the preparation of this article but neither Sound On Sound Limited nor the publishers can be held responsible for its contents. The views expressed are those of the contributors and not necessarily those of the publishers.

Web site designed & maintained by PB Associates | SOS | Relative Media