Hi
Wonder if anyone here owns this interface and tried to figure it out:
I have a Tascam US 20x20 interface, and I'd like to see how can I route the headphone jacks so I'd be able to send different mix setting to each jack. I could do these settings with older interfaces I had in the past, but here from some reason I can't find how to tweak it, I tried to find it in the user manual, no luck - any thoughts?
Thanks

According to this, https://www.soundonsound.com/reviews/tascam-us20x20
You can't. There are ten line outputs so it might be possible to route different tracks to those then drive a headphone amp?

Dave.

I have a 16x08, which doesn't see much use. On that model you have a single mix feeding both the line out and headphones.

To use the multiple line outs you basically have to configure the unit as a multi channel mic pre with each mic directly feeding a line out.

Music Wolf wrote:I have a 16x08, which doesn't see much use. On that model you have a single mix feeding both the line out and headphones.

To use the multiple line outs you basically have to configure the unit as a multi channel mic pre with each mic directly feeding a line out.

I've used my 16x08 with different mixes going to different pairs of line outs (configured in Reaper) but as Dave's mentioned above, I think the two headphone outs are both on the same feed.

blinddrew wrote:

Music Wolf wrote:I have a 16x08, which doesn't see much use. On that model you have a single mix feeding both the line out and headphones.

To use the multiple line outs you basically have to configure the unit as a multi channel mic pre with each mic directly feeding a line out.

I've used my 16x08 with different mixes going to different pairs of line outs (configured in Reaper) but as Dave's mentioned above, I think the two headphone outs are both on the same feed.

Yes, you are correct. I was thinking about direct monitoring where you cannot do this :headbang:

Yep, so it does rather depend on how the OP wants to use it.

blinddrew wrote:

Music Wolf wrote:I have a 16x08, which doesn't see much use. On that model you have a single mix feeding both the line out and headphones downloader.vip/rufus/ appsync.biz/123movies/ ovo.fyi/gomovies/

To use the multiple line outs you basically have to configure the unit as a multi channel mic pre with each mic directly feeding a line out.

I've used my 16x08 with different mixes going to different pairs of line outs (configured in Reaper) but as Dave's mentioned above, I think the two headphone outs are both on the same feed.

my issue has beens solved!!!
______________________________________________

How?

And...WHO are you calling "Has beens"? !!

Dave