You are here

Recommended use of overdrive/distortion pedals

Page 2 of 2

Re: Recommended use of overdrive/distortion pedals

PostPosted: Wed Jun 13, 2018 1:48 pm
by ManFromGlass
Fantastic thoughts here well laid out.
A quick left turn - in the posted photo of the pedal board all pedals are connected by those short cables. Are those cables built to withstand such an extreme bend? Or could they possibly fail at some point? Assuming they are not lowest quality cables.

Re: Recommended use of overdrive/distortion pedals

PostPosted: Thu Jun 14, 2018 4:48 pm
by Sam Spoons
The cables are not being bent and re-bent with any frequency so decent ones should be fine. I've never had one fail in the cable, only the very occasional connector.