I recently picked up a damaged Z1 for cheap.
It had a few broken keys and missing encoder knobs but was working otherwise.
I replaced the broken keys so all good.
However, I'm pretty sure that when I picked it up, the Program/value buttons worked (albeit a bit sticky). I then did a factory reset and they no longer work, however the Page/User group buttons now perform the same function, i.e if if press them they increment/decrease programs by one! (whereas according to manual it should move to programs in same category). I re-did the factory reset a few times... same behaviour.
Any idea what could be wrong? Can't find any global settings that could affect that.
I should point out that that behaviour changed before I opened it to change the broken keys so unlikely to be the result of plugin/unpluging cables inside.
Any ideas welcome.
You are here
Any Korg Z1 users out there? Value/program buttons not working.
For fans of synths, pianos or keyboard instruments of any sort.
1 post • Page 1 of 1
- New here
- Posts: 5
- Joined: Wed Jan 04, 2017 12:00 am
Who is online
Users browsing this forum: No registered users