You are here

How do I connect active monitor to Behringer PA?

Page 1 of 1

How do I connect active monitor to Behringer PA?

PostPosted: Wed Jul 18, 2018 12:52 pm
by ptate
Very simple answers please.......... :? :D :?

How do I connect my Mackie SRM350 active monitor to my Behringer PMP530M for stage use (so the drummer can hear the mix). It's my son's band, so guitar, bass, drums and 2 vox. It's a small gig set up.

I usually use two 12 inch piggybacked 8ohm cabs to give the 4ohm Behringer specified output, but don't want to destroy the mixer by adding the Mackie incorrectly.

Just want a really simple drawing or explanation please.....!

Peace

Re: How do I connect active monitor to Behringer PA?

PostPosted: Wed Jul 18, 2018 12:57 pm
by Janneman
Use aux or record out and then r and l input. Gain on line in.

Give it a try.

Re: How do I connect active monitor to Behringer PA?

PostPosted: Wed Jul 18, 2018 2:52 pm
by Sam Spoons
That's about the only way, (and use rec not aux as aux is an input on the Berry). You could only do harm if you tried to plug the speaker outputs into the Mackie so don't do that, otherwise feel free to experiment.

Re: How do I connect active monitor to Behringer PA?

PostPosted: Wed Jul 18, 2018 8:37 pm
by ptate
Thanks very much for the replies...!! :thumbup: :thumbup: :thumbup:

Re: How do I connect active monitor to Behringer PA?

PostPosted: Wed Jul 18, 2018 8:38 pm
by Janneman
ptate wrote:Thanks very much for the replies...!! :thumbup: :thumbup: :thumbup:


Sam is right abot the aux. Sorry for that.