I am recording using a spaced-pair miking setup and I want to apply light compression to the signal. Where in the signal chain should I insert the compressor (pre- or post-fade), and will I have to buy a dedicated stereo compressor to do the job properly?
I record guitar using a Line 6 Pod Pro going into a Roland VMC7200 mixing desk via S/PDIF. While the guitar is plugged in, every so often a little audio spike comes through the monitors. Can you tell me what this noise could be and how to stop it?
In my hardware-based setup, with my TC electronics Triple*C compressor, is it possible to do the kind of limiting on a full mix where you end up with a waveform that is levelled off at the top and bottom, 'brick wall'-style?
What advantages are there to variable input impedance? • How can I extract loops from audio sample CDs? • Can I use the True Tape option in Cubase to prevent clipping? • Should I use S/PDIF or AES for long cable runs? • Can you have too much low-frequency absorption? • What's the best way to use the multiple filters on my soft synth?