Q. How do I set up a monitoring reverb inside Cubase? : November 2007
Q. How do I set up a monitoring reverb inside Cubase? Published in SOS November 2007  Printer-friendly versionSound Advice I use Cubase SX v1 and I want to set up a reverb that the vocalist can hear during recording, but that doesn't get recorded with the vocal. Is there a good way to do this?
Steve Nunn Features Editor Sam Inglis replies: Yes, in simple terms. But you need to switch Direct Monitoring off. (In Cubase 4, this can be found in the Device Setup / VST Audio System menu, but the menus have been reshuffled over the last few updates, so it's best to check your manual to locate its whereabouts). When you've done that, you should hear your input signals with any reverb or other effects you're sending to from the input tracks, but your signal will still be recorded dry. The down side is that you may have noticeable latency while recording in this mode. Published in SOS November 2007 | Sunday 6th July 2008 July 2008
Click image for Contents
Other recent issues: WIN Great Prizes in SOS Competitions!
|
