Q. What are filters and what do they do?

Essentially, EQ is used to boost or attenuate (turn down) a range of frequencies in order to shape a sound. High-pass and low-pass filters are common in professional equalisers, but less common in budget designs. They are used to define the highest and lowest frequencies of interest in the signal and they pretty much do what their names suggest: let audio above a certain frequency pass (high-pass filter) or audio below a certain frequency pass (low-pass filter). Anything outside those limits is attenuated. They are also called low-cut or high-cut filters, but the function is the same.

Filters are defined by their slope, which determines the attenuation of signals outside the ‘pass’ band. Most audio filters on mixing desks (and DAWs) will have a slope of 12dB or 18dB per octave, and in synthesizer filters the slope may be as steep as 24dB per octave. If an 18dB/octave high-pass filter is set to 80Hz, any audio an octave below that (at 40Hz) will be attenuated by 18dB, and an octave lower still, at 20Hz, it will be attenuated by 36dB... and so on.

High- and low-pass filters generally have much steeper slopes than the more normal equaliser bands (which are typically only 6dB/octave) and are intended for a different purpose. You can’t effectively remove rumble with a bass EQ control, but you can with a high-pass filter. But equally, you can’t shape the tone of a bass guitar with a high-pass filter as easily as you can with a bass EQ control.

Filters are used for ‘corrective’ equalisation, as opposed to creative equalisation. They are used to clean up a signal, rather than to shape the sound creatively. They only provide attenuation of unwanted frequencies, and there’s no scope to boost any part of the frequency range. Of the two, the high-pass filter is probably the most useful, as it helps to remove unwanted rumbles and other unwanted sub-sonic rubbish that microphones tend to capture. Most DAW software includes a software EQ that you’ll be able to use to perform any of these tasks, and although I’m not personally familiar with Cakewalk Project 5, I notice that it can host third-party VST plug-ins, so there are many freeware plug-ins that you could use if your DAW doesn’t have them built in.  0